Therefore, we decided to use the RCF Horn H100.
This horn was then combined with an Eminence Delta 10 bass driver. Care had
to be taken to separate this bass driver from the tweeter by using two capacitors.
Distinct distortion develops from approx. 100 Watts onwards since the voice
coil leaves the linear range; However, this is quite advantageous for home
cinema considering that a comparable hi-fi speaker needs a 1000 Watt amplifier
to produce the same volume.
Measured at an angle below 30 degrees the volume above 15 kHz is approx.
10 dB lower.
The crossover components should be mounted on a wooden board and then fitted
in empty space. The terminal should be mounted on the rear panel of the cabinet.
For hi-fi we recommend in addition to the napped foam 1 1/2 bags of damping fleece
Price per unit without cabinet and wood:
EUR 286,00 excl. VAT: € 240.34 / $ 278.79
Hint: upon request we also supply - instead of Speakon connector
- a terminal with 2 gold plated brass binding posts at no additional charge.
If you prefer to mount the crossover components on a Cu PCB instead on wood:
Price for PCB 205 x 140 mm
EUR 11,70 excl. VAT: € 9.83 / $ 11.41